The blower motor of the 2014 Chevy Equinox is located in the engine compartment, near the firewall on the passenger side. It is mounted to a bracket and held in place with two screws. To access it, you need to remove several components including the air cleaner assembly and inner fender liner.
Once these are removed, you can access and disconnect wiring harnesses from the blower motor itself before removing it from its bracket. After installation of a new or used blower motor, be sure to reconnect all wiring harnesses securely before reinstalling any other components that were removed for access purposes.
Credit: sparkys-answers.com
2014 Chevy Equinox Blower Motor Resistor Location
The blower motor resistor on a 2014 Chevy Equinox is located directly behind the glove box, which can be accessed by removing two screws from the bottom of the glove box. Once access to the area has been gained, you will see a black plastic panel with three electrical connections and four bolts that need to be removed in order to take out the old resistor.
Replacing it should only take a few minutes once all connections have been properly detached.
2014 Equinox Blower Motor Resistor
The 2014 Equinox Blower Motor Resistor is an important component of the heating and cooling system in your vehicle. It helps regulate the current flow to the blower motor which controls air speed from the vents.
If you experience any issues with limited airflow or no airflow at all, it may be due to a faulty resistor that needs to be replaced.
2013 Chevy Equinox Blower Motor
The 2013 Chevy Equinox blower motor is a durable and reliable part that helps to keep the cabin of your vehicle comfortable. The motor works by pushing air through the vents, which in turn circulates heat or air conditioning throughout the car.
If your blower motor isn’t working properly, it could be a sign of a bigger problem such as an electrical issue. It’s important to get this checked out right away so you can stay comfortable on all your drives!
2012 Equinox Blower Motor Intermittent
The 2012 Equinox Blower Motor can sometimes suffer from intermittent issues, such as not starting when the vehicle is initially started or randomly turning off while driving. These problems are usually caused by a faulty relay switch or motor resistor, both of which should be replaced to fix the issue.
Additionally, it’s important to check all wires and connections for any loose or damaged components that could be causing the blower motor to act erratically.
2013 Chevy Equinox Blower Motor Resistor Location
The blower motor resistor for the 2013 Chevy Equinox is located in the fuse box under the glove compartment on the passenger side of the vehicle. It’s important to make sure that this component is working properly to ensure your air conditioning and heating system will function correctly.
The resistor can be replaced easily with basic tools, but be sure to consult a certified mechanic if you have any questions or concerns about replacing it yourself.
2013 Equinox Blower Motor Resistor
The 2013 Equinox Blower Motor Resistor is a critical component in the climate control system of your vehicle. It helps to regulate the amount of power going to your blower motor, allowing you to adjust its speed and airflow direction accordingly. Without it, you would be unable to switch between several fan speeds or choose which vents are blowing air.
If this part malfunctions, it can cause erratic fan speeds or complete loss of blower motor operation. Replacing the resistor will often restore normal function and ensure that your cabin remains comfortable again.
2011 Chevy Equinox Blower Motor Resistor
The 2011 Chevy Equinox Blower Motor Resistor is a critical component in the vehicle’s climate control system and helps regulate the speed of the fan motor. It can cause a variety of issues if it fails such as unpredictable fan speeds, no air blowing out at all or even overheating.
The good news is that replacing this part isn’t too difficult and can be done with some basic tools and mechanical know-how.
Where is the Blower Motor Located on a Chevy Equinox?
The blower motor on a Chevy Equinox is located in the cabin air filter housing which can be accessed through the engine compartment. The air filter housing should be positioned in front of the driver side wheel well and is accessible by removing two bolts from either side of it. Once you have removed the screws, you will need to remove the entire assembly.
Inside this assembly there are several components including an evaporator core, condenser coil, heater core, and finally your blower motor. You will find that your blower motor is attached to a bracket at one end with electrical connectors at the other end for attaching wires from elsewhere within your vehicle’s climate control system. With all connections detached you can now carefully remove your blower motor for inspection or replacement as needed.
Where is the Blower Motor Located?
The blower motor is located inside the vehicle, typically underneath the dashboard on the passenger side. Depending on your make and model of car, it can be located in various locations. In most cases, you will need to remove several interior panels to gain access to the blower motor.
Once you have access to the area where it’s located, you should be able to see it mounted in its proper place. The blower motor is responsible for circulating air through your vehicle’s heating and cooling system. Without this important component, your car would not be able to keep a comfortable temperature or provide ventilation when needed.
If there are any issues with your heater or AC system that seem related to airflow problems, chances are that replacing or repairing the blower motor may be necessary in order for these systems to function properly again.
Why is My Equinox Not Blowing Air?
If you are experiencing an issue with no air coming out of your Equinox, there could be a few reasons why. First, check the fan setting on the climate control system and make sure it is set to ON. If that doesn’t work, then it may be possible that your blower motor has gone bad or something is blocking the airflow from entering into the cabin of your vehicle.
Another potential problem could be a faulty blower resistor which can cause an electrical short in the circuit and prevent air from flowing. It’s also possible that one of the hoses leading to or from your heater core have become clogged with debris or even worse cracked and need to be replaced completely. Lastly, if none of these seem to resolve the issue then it might mean you have a more serious problem like a broken belt or pulley in your car’s engine bay which would require professional inspection.
How Do I Know If My Blower Motor is Bad?
If you suspect that your blower motor is bad, one of the most telling signs is that it will not blow any air through the vents. This can be a sign of an issue with the fan belt or a problem with the actual motor itself. Other indicators may include noises coming from within the unit such as humming, buzzing, or grinding sounds which could indicate something wrong with its internal components.
You may also notice an odor when the blower is running or even see smoke if there are electrical issues at play. If your blower isn’t working properly and these signs seem to present themselves, it’s time to take a closer look and have a professional diagnose what might be going on with it.
NO HEAT | Equinox test & replace blower motor
Conclusion
In conclusion, the blower motor location in a 2014 Chevy Equinox is located behind the glove compartment. It is important to note that this process will require removing several components such as the heater core box and evaporator core before accessing it.
With careful preparation and attention to detail, anyone can easily locate their 2014 Chevy Equinox blower motor and install any necessary repairs or replacements.